Relationship table#

Section	Clause	Description	Applicability
	Preface		Accepted
1	Scope		Accepted
2	Objective		Accepted
3	Referenced documents		Accepted
4	Definitions
4.1	Bus lane		Accepted
4.2	Bus only		Accepted
4.3	High occupancy motor car symbol		Accepted
4.4	May		Accepted with amendments
4.5	Road Rules		Accepted, with amendments
4.6	Shall		Accepted with amendments
4.7	Should		Accepted, with amendments
4.8	Traffic control device		Accepted, with amendments
4.9	Tram lane		Accepted
4.10	Tram only		Accepted
4.11	Transit lane		Accepted
4.12	Truck lane		Accepted
4.13	Registered Professional Engineer of Queensland (RPEQ)		New
4.14	Innovative treatments		New
5	Signs
5.1	General		Accepted
5.2	Signs for bus and bus only lanes		Accepted
5.3	Signs for transit lanes		Accepted
5.4	Sign for truck lanes		Accepted
5.5	Signs for tram and tram only lanes		Accepted
5.6	Supplementary plates		Accepted
5.7	Vehicle prohibitions signs		Accepted
6	Pavement markings
6.1	Longitudinal markings		Accepted
6.2	Pavement messages
6.2.1	Message		Accepted
6.2.2	Design for low- and high-speed roads		Accepted
6.3	Pavement colour		Accepted
7	7	Application of signs and markings
7.1		General principles	Accepted
7.2		Common treatments	Accepted, with amendments
8		Variation to treatments and Registered Professional Engineer of Queensland certification	New
		Appendices
A		Illumination and reflectorization of signs (informative)
A1		Scope	Accepted
A2		General	Accepted
A3		Means of illumination	Accepted
A4		Means of reflectorization	Accepted
B		Installation and location of signs (informative)
B1		Scope	Accepted
B2		Uniformity of location
B2.1		General	Accepted
B2.2		Longitudinal placement	Accepted
B2.3		Lateral placement and height
B2.3.1		General	Accepted
B2.3.2		Lateral placement – Rural	Accepted
B2.3.3		Lateral placement – Urban	Accepted
B2.3.4		Height – Rural	Accepted
B2.3.5		Height – Urban	Accepted
B2.3.6		Overhead mounting	Accepted
B3		installation – Sign orientation	Accepted
C		Sign size selection (informative)
C1		Scope	Accepted
C2		Size of signs	Accepted
C3		General principles for size selection	Accepted