Skip to content
TTM WIKIby TekSwipe Traffic
  • Search
  • Ask AI
  • Quiz
  • Library
  • About
  • TekSwipe ↗
Sign in
Library›MRTS265
MRTS265

Contents

  • Copyright
  • 1Introduction
  • 2Definition of terms
  • 3Reference documents
  • 4Quality system requirements
  • 5Type-2 Overview
  • 6Type-2 Functional requirements
  • 7Type-2 Communication requirements
  • 8Type-2 PTSS monitoring, reporting and fault requirements
  • 9Type-2 Mechanical and physical requirements
  • 10Type-2 Electrical requirements
  • 11Type-2 Portable traffic signal lantern photometric performance
  • 12Type-2 Documentation Requirements
  • 13Type-2 Testing, commissioning and configuration requirements
  • 14Type-2 Warranty provisions
  • 15Type-2 Training requirements
  • 16Type-2 Maintenance requirements
  • 17Type-2 Handover requirements

14Type-2 Warranty provisions#

The warranty requirements defined in MRTS201 General Equipment Requirements apply to this Technical Specification.

Source: MRTS265 · page 14 Open PDF at this page Search this document
← Previous13 Type-2 Testing, commissioning and configuration requirements Next →15 Type-2 Training requirements
TEKSWIPE TRAFFICTraffic management design & software · Cairns, QLD

TTM Wiki is built by TekSwipe Traffic. Need a traffic guidance scheme? Order a plan from TekSwipe Traffic ↗

TTM Wiki

  • Search
  • Ask AI
  • Quizzes
  • Document library
  • About

TekSwipe Traffic

  • tekswipetraffic.com.au ↗
  • Chainage — QLD chainage finder ↗

Unofficial reference. Always confirm requirements against the current official publication. Source documents © State of Queensland, used under their published licences.