3Reference documents#
The requirements of the referenced documents listed in Table 3 of MRTS201 General Equipment Requirements and Table 3 following in this Technical Specification apply to this Technical Specification. Where there are inconsistencies between this Technical Specification and referenced MRTS documents, the requirements specified in this Technical Specification take precedence.
Table 3 – Referenced documents
| Reference | Title |
|---|---|
| AS 1170.2 | Structural Design Actions – Wind Actions |
| AS 1742.7 | Manual of Uniform Traffic Control Devices – Railway crossings |
| AS 2144 | Traffic Signal Lanterns |
| AS 2700 | Colour Standards for General Purposes |
| AS 4191 | Portable Traffic Signals |
| AS 60529 | Degrees of Protection Provided by Enclosures (IP Code) |
| AS/NZS 4509.1 | Stand-alone Power Systems – Safety and Installation |
| AS/NZS 4509.2 | Stand-alone Power Systems – System Design |
| AS/NZS CISPR 32 | Electromagnetic compatibility of multimedia equipment – Emission requirements |
| LIPD | Low Interference Potential Devices – Class Licence 2015 |
| MRTS01 | Introduction to Technical Specification |
| MRTS02 | Provision for Traffic |
| MRTS50 | Specific Quality System Requirements |
| MRTS61 | Gantries and Support Structures for Road Signs, Tolling Systems and ITS Devices |
| MRTS201 | General Equipment Requirements |
| MRTS264 | Type-1 Portable Traffic Signals |
| MRTS265 | Type-2 Portable Traffic Signals |
| MUTCD Part 3 | Queensland Manual of Uniform Traffic Control Devices (MUTCD) – Part 3 Traffic control for works on roads |
| Guideline – Traffic Management at Works on Roads, Chapter 5 | Guideline for Traffic Management at Works on Roads |