Skip to content
TTM WIKIby TekSwipe Traffic
  • Search
  • Ask AI
  • Quiz
  • Library
  • About
  • TekSwipe ↗
Sign in
Library›Cones & Bollards Technical Requirements
Cones & Bollards Technical Requirements

Contents

  • Copyright
  • 1Enquiries
  • 2Introduction
  • 3Governing manuals and associated specifications and guidelines
  • 4Acceptance of new products as suitable for use in Queensland
  • 5Conditions of Acceptance
  • Appendix ACones and Bollards – Acceptance Checklist
  • SECTION A1APPLICANT INFORMATION
  • SECTION A2CONES CHECKLIST
  • SECTION A3BOLLARDS CHECKLIST
  • A4APPLCIANT DECLARATION

1Enquiries#

If you have any questions regarding this document, suggestions for improvement, or would like to submit a product for acceptance for use in Queensland, please contact:

TrafficEngineering.Support@tmr.qld.gov.au

Source: Cones & Bollards Technical Requirements · page 4 Open PDF at this page Search this document
← PreviousCopyright Next →2 Introduction
TEKSWIPE TRAFFICTraffic management design & software · Cairns, QLD

TTM Wiki is built by TekSwipe Traffic. Need a traffic guidance scheme? Order a plan from TekSwipe Traffic ↗

TTM Wiki

  • Search
  • Ask AI
  • Quizzes
  • Document library
  • About

TekSwipe Traffic

  • tekswipetraffic.com.au ↗
  • Chainage — QLD chainage finder ↗

Unofficial reference. Always confirm requirements against the current official publication. Source documents © State of Queensland, used under their published licences.