2Definition of terms#

The terms defined in MRTS201 General Equipment Requirements apply to this Technical Specification. Additional terminology relevant under this Technical Specification are defined in Table 2 below.

Table 2 – Definitions of terms
TermDefinition
ActRadio Communications Act 1992 and associated regulations and codes of practice.
ApproachThat section of road, consisting of one or more lanes, used by vehicles approaching an intersection or mid-block site.
DisplayA signal aspect that is illuminated.
Fixed Time operationA signal operation mode that allows for only a fixed sequence and fixed duration of displays.
Flashing yellow operationA signal operation mode where the yellow aspects continually flash.
Manual operationA signal operation method where each phase is individually controlled by manually entering a command for the next phase.
Master controllerThe internal control processing unit hardware within the Master PTS unit which undertakes all communication and internal processing tasks required for operation. This controller controls the Slave controller operations.
NATANational Association of Testing Authorities, Australia.
Operation ModesPTSS Type-1 operation mode is manual only.
Portable Traffic Signal Unit (PTSU)An individual portable traffic signal that consists of the traffic signal lantern, battery, communications equipment, mounting assembly and base.
Portable Traffic Signals System (PTSS)Traffic light signals and associated equipment that provides signalling for temporary control of traffic at work sites.
RPEQRegistered Professional Engineer of Queensland.
Hand-held Remote Controller (HRC)A hand-held remote / device which can control and set the PTSS lanterns at a safe distance. This device may be wired or wireless.
Slave controllerThe internal control processing unit hardware within the slave PTSU which undertakes all communication and internal processing tasks required for operation. This unit is subservient to the Master controller to which it is linked.
Traffic ControllerA person authorised to control traffic movements through site works by means of flags, stop / slow bats or other equipment.
Yellow TimeDuration of the yellow signal for a phase or movement. This is static and pre-specified.
Source: MRTS264 · page 5 Open PDF at this page Search this document