3Referenced documents#

3.1 The requirements of the referenced documents listed in Table 3.1 below apply to this Technical Specification. Where there are inconsistencies between this Technical Specification and the referenced documents, the requirements in this Technical Specification shall take precedence.

Table 3.1 – Reference documents
ReferenceTitle
Australian / New Zealand Standards
AS 1742Manual of uniform traffic control devices
AS 1906.3Retroreflective materials and devices for road traffic control purposes, Part 3: Raised pavement markers (retroreflective and non-retroreflective)
AS 2009Glass beads and particles for pavement marking materials
AS 2700Colour standard for general purpose
AS 4049.2Paints and related materials – Pavement marking materials Part 2 – Thermoplastic pavement marking materials – For use with surface applied beads
AS 4049.3Paints and related materials – Pavement marking materials Part 3 – Waterborne paint – For use with surface applied Beads
AS 4049.4Paints and related materials – Pavement marking materials Part 4: High performance pavement marking systems
Austroads
AP-C87-15Austroads Glossary of Terms
AGPT-T800Assessment of retroreflectivity of pavement markings
AGTTM-SETGuide to Temporary Traffic Management
Australian Paint Approval Scheme (APAS)
APAS 0041/2Pavement marking paint, solvent-borne
APAS 0041/3Pavement marking material, cold applied plastic
APAS 0041/4Pavement marking paint, thermoplastic
APAS 0041/5Pavement marking paint, water-borne
APAS 0042Glass beads for use in pavement marking paints
National Transport Commission
ADG CodeAustralian Code for the Transport of Dangerous Goods by Road and Rail
Transport and Main Roads Technical Documents
MRTS01Introduction to Technical Specifications
MRTS50Specific Quality System Requirements
MRTS110Coloured Surface Treatments
MRTS111High Friction Surface Treatments
QGTTMQueensland Guide to Temporary Traffic Management
Queensland MUTCDQueensland Manual of Uniform Traffic Control Devices
QGRSQueensland Guide to Road Safety
RPDMRoad Planning and Design Manual 2nd Edition Volume 3, Part 3 Geometric Design
Source: MRTS45 · page 8 Open PDF at this page Search this document