3Legislation and Standards#

The following Australian Standards and Regulatory Acts shall be referenced.

ReferenceTitle
-Electrical Safety Regulation 2013 (Queensland)
-Electrical Safety Act 2002 (Queensland)
-Managing Electrical Risk in the Workplace – Code of Practice – Safe Work Australia
AS 2578:2009Traffic signal controllers
AS/NZS 3000:2007Electrical installations (known as Wiring Rules)
AS/NZS 3017:2007Electrical installations – Verification guidelines
AS/NZS 3019:2007Electrical installations – Periodic verification
AS/NZS 3947.3:2001Low-voltage switchgear and controlgear – Switches, disconnectors, switch-disconnectors and fuse-combination units
AS/NZS 4836:2011Safe working on or near low-voltage electrical installations and equipment
AS/NZS 5000.1:2005Electric cables – Polymeric insulated – For working voltages up to and including 0.6/1 (1.2) kV
AS/NZS 5000.2:2006Electric cables – Polymeric insulated – For working voltages up to and including 450/750 V
AS/NZS ISO 31000:2009Risk management – Principles and guidelines
AS 61010Safety requirements for electrical equipment for measurement, control and laboratory use.
AS 60269:2005Low voltage fuses
AS/NZS 60529:2004Degrees of protection provided by enclosures (IP code)
AS 60947.4.1–2004Low-voltage switchgear and controlgear – Contactors and motor- starters – Electromechanical contactors and motor-starters
Source: TRUM Vol 4 Part 6 · page 5 Open PDF at this page Search this document