Skip to content
TTM WIKIby TekSwipe Traffic
  • Search
  • Ask AI
  • Quiz
  • Library
  • About
  • TekSwipe ↗
Sign in
Library›MRTS201
MRTS201

Contents

  • Copyright
  • 1Introduction
  • 2Definition of terms
  • 3Referenced documents
  • 4Quality system requirements
  • 5Statutory compliance
  • 6Functional requirements
  • 7Equipment
  • 8Operational requirements
  • 9Control system
  • 10Electrical requirements
  • 11Telecommunications requirements
  • 12Mechanical and physical requirements
  • 13Enclosures
  • 14Storage
  • 15Installation requirements
  • 16Testing and commissioning
  • 17Documentation
  • 18Training
  • 19Maintenance
  • 20Handover
  • Appendix AExample Table of Contents for Operational Manuals
  • Appendix BProvision for thermal testing of enclosures
  • B1Introduction
  • B2Definitions of terms and notations
  • B3Reference documents
  • B4Purpose of the test
  • B5Temperature range of ITS equipment
  • B6Temperature control devices
  • B7Description of test parameters
  • B8Test procedure
  • B9Documentation of test results

B5Temperature range of ITS equipment#

ITS and Electrical enclosures must maintain an internal temperature below the temperature operating range of equipment installed in the cabinet. Unless specified otherwise, the cabinet shall maintain an internal temperature (TI) below 50°C.

Source: MRTS201 · page 56 Open PDF at this page Search this document
← PreviousB4 Purpose of the test Next →B6 Temperature control devices
TEKSWIPE TRAFFICTraffic management design & software · Cairns, QLD

TTM Wiki is built by TekSwipe Traffic. Need a traffic guidance scheme? Order a plan from TekSwipe Traffic ↗

TTM Wiki

  • Search
  • Ask AI
  • Quizzes
  • Document library
  • About

TekSwipe Traffic

  • tekswipetraffic.com.au ↗
  • Chainage — QLD chainage finder ↗

Unofficial reference. Always confirm requirements against the current official publication. Source documents © State of Queensland, used under their published licences.