BG800 Steel Gate#

9:37 AM Monday, 26 May 2025

Created:

Status*: Accepted

Status Commencement Date: Jun 2014

Status Expiry Date*: Not Set

Category: Longitudinal

Sub Category: Semi-Rigid

Main Material: Steel

Ownership: Highway Care International http://www.highwaycareint.com

Introduction: BarrierGuard 800 Steel Gate is a hinged steel barrier “gate” intended primarily to provide openings in permanent concrete barrier and to provide construction access in runs of temporary BarrierGuard 800.

Page 1 of 2

Gating/Non-Gating: Not Applicable

Redirective/Non-Redirective: Redirective

Permanent/Temporary: Permanent

Supplier: Ingal Civil Products 7 Nestor Drive, Meadowbrook QLD 4131 Ph: 3489 9120 Fax: 3489 9130 www.ingalcivil.com.au

Test Level: NCHRP Report 350 TL-3

Recommended End Treatments: No end treatment as the gate is embedded into longitudinal barrier system.

Page 2 of 2

Design#

BarrierGuard 800 Steel Gate is a hinged steel gate comprising 6 metre and 12 metre sections of Barrierguard 800 steel barrier with “T-Top” attachments. The system is 540 mm wide, and 915 mm high. The maximum length of gate is 30 metres (on the basis of operational manageability). The system is tested on longer lengths. The system should be installed on smooth level ground. The intended sweep of the gate should be free from kerbs or rapid changes in gradient. Designer should check with supplier for site specific foundation requirements.

References#

  • Australian Standard AS/NZS 3845
  • NCHRP Report 350
  • TMR Road Planning and Design Manual
  • Austroads determination letter dated 14 March 2014
  • NSW RMS Acceptance Document dated 14 March 2014
  • FHWA letter Ref: HSSD/B-159 dated 8 May 2007

Deflection#

Measured (Crash Test) Deflections:

Nominal Mass (kg)Nominal Angle (deg)Nominal Speed (km/h)Recorded Deflection (m)Note
2,000251001.1621

Limitations#

Wheels must be fully retracted when not in use. Posted speed should be restricted to 40 km/h when gate is open unless exposed barrier ends can be otherwise shielded.

  • BarrierGuard 800 Installation Manual – Laura Metaal, Version 2.6
  • Austroads acceptance documents dated 06-Mar-2018 (Steel Gate)

Drawings from the original pages

Source: Accepted Road Safety Barrier Systems & Devices · pages 55–56 Open PDF at this page Search this document