Skip to content
TTM WIKIby TekSwipe Traffic
  • Search
  • Ask AI
  • Quiz
  • Library
  • About
  • TekSwipe ↗
Sign in
Library›TRUM Vol 3 Part 5›Appendix B Design procedure for roadside sign support
TRUM Vol 3 Part 5

Contents

  • Copyright
  • Licence
  • CC BY licence summary statement
  • Translating and interpreting assistance
  • Disclaimer
  • Feedback
  • 1Scope and introduction
  • 2Design wind pressure
  • 3Clear zone criteria
  • 4Sign face construction
  • 5Sign supports
  • 6Storage and handling of signs
  • Appendix ATraSiS
  • Appendix BDesign procedure for roadside sign support
    • Step 1
    • Step 2
    • Step 3
    • Step 4
    • Step 5
    • Step 6
    • Step 7
    • Sample calculation
    • Step 1
    • Step 2
    • Step 3
    • Step 4
    • Step 5
    • Step 6
    • Step 7
  • Appendix CStandard Drawings
  • Appendix DDevelopment of the 2018 Design Guide
  • Appendix EDesign of sight boards and other signs at T-intersections

Step 3#

Low risk exposure as behind a guard rail – breakaway details not required.

Source: TRUM Vol 3 Part 5 · page 35 Open PDF at this page Search this document
← PreviousStep 2 Next →Step 4
TEKSWIPE TRAFFICTraffic management design & software · Cairns, QLD

TTM Wiki is built by TekSwipe Traffic. Need a traffic guidance scheme? Order a plan from TekSwipe Traffic ↗

TTM Wiki

  • Search
  • Ask AI
  • Quizzes
  • Document library
  • About

TekSwipe Traffic

  • tekswipetraffic.com.au ↗
  • Chainage — QLD chainage finder ↗

Unofficial reference. Always confirm requirements against the current official publication. Source documents © State of Queensland, used under their published licences.