6Install heat shrink sleeves onto base#

Figure 6 – Install heat shrink sleeves onto base
Figure 6 – Install heat shrink sleeves onto basep. 7

SLEEVE – Slide the glue-free end of the heat-shrink sleeve onto the prepared port. · HEAT – Using an approved heat source, gently heat the glue-free end of the heat shrink, taking care not to concentrate the heat in one spot and ensuring the section with the glue is not heated. · COOL – Allow cooling for 10 minutes before installing cables.

Drawings from the original pages

Figure 5 – Prepare entry portsp. 7
Source: TRUM Vol 4 Part 4 · page 7 Open PDF at this page Search this document