Skip to content
TTM WIKIby TekSwipe Traffic
  • Search
  • Ask AI
  • Quiz
  • Library
  • About
  • TekSwipe ↗
Sign in
Library›TRUM Vol 4 Part 5
TRUM Vol 4 Part 5

Contents

  • Copyright
  • 1Introduction
  • 2Scope
  • 3Definition of terms
  • 4Reference documents
  • 5Technology options
  • 6Placement and installation of vehicle detection loops
    • 6.1Sensor placement for vehicle detection site
    • 6.2Sensor installation for vehicle detection site
  • 7Placement and installation of traffic counter / classifier
    • 7.1Site selection
    • 7.2Applicable standard drawings
    • 7.3Sensor placement at traffic counter / vehicle classifier site
    • 7.4Sensor installation for traffic counter / vehicle classifier site
      • 7.4.1Numbering of sensors
      • 7.4.2Pneumatic tube installation
      • 7.4.3Inductive loop installation
      • 7.4.4Piezoelectric sensor installation
  • 8Placement and installation of high-speed weigh-in-motion sensors
  • 9Placement and installation of active transport sensors
    • 9.1Site selection
    • 9.2Applicable standard drawings
    • 9.3Sensor placement at active transport site
    • 9.4Sensor installation for active transport counter/classifier (ATCC) site

6Placement and installation of vehicle detection loops#

Source: TRUM Vol 4 Part 5 · page 9 Open PDF at this page Search this document
← Previous5 Technology options Next →6.1 Sensor placement for vehicle detection site
TEKSWIPE TRAFFICTraffic management design & software · Cairns, QLD

TTM Wiki is built by TekSwipe Traffic. Need a traffic guidance scheme? Order a plan from TekSwipe Traffic ↗

TTM Wiki

  • Search
  • Ask AI
  • Quizzes
  • Document library
  • About

TekSwipe Traffic

  • tekswipetraffic.com.au ↗
  • Chainage — QLD chainage finder ↗

Unofficial reference. Always confirm requirements against the current official publication. Source documents © State of Queensland, used under their published licences.